Thursday, July 9, 2015

Arduino ACS712 Current Sensor

The ACS712 is a very easy to use bi-directional current sensor. It comes in 5, 20, and 30 amp versions, and there's only one line of code that needs to be changed depending on which unit you have. This sensor outputs a small voltage that increases with current flowing through the sensor. It isolates the current being monitored from the Arduino, so there's no risk to the Arduino. Most breakout boards come with the needed resistors and caps already installed, so physical hookup consists of +5vdc, gnd, and analog out to one of the Arduino analog inputs. The polarity sensitive current sense pins connect in series with one of the power wires to the device being monitored (either production, or consumption).

In the picture above, looking at the lower right image, the left terminal is the more positive terminal, and the right terminal is the more negative terminal. If you reverse these, you will see negative current readings when you expect positive current readings.

Alternative method, using a shunt!

Parts needed:
Arduino UNO
ACS712 5a (20a, or 30a options)

ACS712 Datasheet


Measuring Current Using ACS712
const int analogIn = A0;
int mVperAmp = 185; // use 185 for 5A Module, 100 for 20A Module and 66 for 30A Module
int RawValue= 0;
int ACSoffset = 2500; 
double Voltage = 0;
double Amps = 0;

void setup(){ 

void loop(){
 RawValue = analogRead(analogIn);
 Voltage = (RawValue / 1023.0) * 5000; // Gets you mV
 Amps = ((Voltage - ACSoffset) / mVperAmp);
 Serial.print("Raw Value = " ); // shows pre-scaled value 
 Serial.print("\t mV = "); // shows the voltage measured 
 Serial.print(Voltage,3); // the '3' after voltage allows you to display 3 digits after decimal point
 Serial.print("\t Amps = "); // shows the voltage measured 
 Serial.println(Amps,3); // the '3' after voltage allows you to display 3 digits after decimal point

Additional reading:


  1. Hi may i know how to get the AC offset value? If my AC sensor module is a 20A moudle, i have to change the mVperAmp=100; ??
    If so will the Acoffset value have to be changed too?

    1. The offset value is VCC/2 regardless of which module you use. With a 5v input, the offset is 5/2 = 2.5, which is 2500 millivolts.

  2. what will be the output of the program?

  3. can this code measure ac voltage?

    1. See code at


Related Posts Plugin for WordPress, Blogger...